Saturday, 15 October 2011

Hammer A3 41 review.

Sorry for the rather long gap between postings, what with one thing and another, time has been very tight lately. But I have my whole house to furnish soon, starting with my kitchen. Anyway here is a short review of my new planer thicknesser,
 Ordered this machine in July, it was delivered this week, a long wait for sure, but it was worth it, and a week earlier than stated. It was explained to me at the time, that there would be this wait. Mainly because they have just changed the design a bit and new machinery for making these was being installed in Austria.
I’m making my own kitchen at the moment, and I’ve wasted no time putting this machine through it paces. It delivers smooth, flat, and square timber. The fence is robust, and doesn’t have a massive centre bar, so can be pushed right back flat to the wall. Both tables flip at the same time, and the change over from planer to thicknesser is very fast with just two decent solid handles that quick release both beds. I have the wheel kit on mine, and would say this is an essential add on if your tight for space(as I am). I also opted for the digital readout on the thicknesser, and would say this is a good option also. On my older P/T the extraction wasn't that efficient, so using the fitted hood on the A3-41 was a revelation, the extractor hood is very efficient at picking up all but a few of the chips, and after machining for most of the day there was perhaps a handful of chips around the machine.
Now the bad bits, this machine has been keenly priced to be in-line with its competitors, so there have been a few corners cut on things like adjusting knobs. These feel cheap and nasty, and I don’t feel they have much longevity or a place on a machine in this class. The manual was all in German, but they are sending me an English version this coming week(it came the next day).
That being said, I wish I had got my hands on one sooner, the smooth finish alone has made sanding a much quicker job now, and I’m very happy with this machine. I would however, probably of paid a few pounds more to get metal adjustment knobs instead of the few(not all) plastic ones its supplied with. Hope this helps.


I have since used this planer a lot and have tested the full width with oak, I have taken 2mm off in one hit, and the machine handled it without missing a beat.

Thanks for looking.


  1. Thats pretty cool. I am a sucker for a gigantic cast iron bed on any tool. Someday, I'll upgrade my current planer. I am jealous. :)

  2. As well you should, this is a great machine. Definitely take a look at the hammer when you upgrade Jeff I like it.